bing tracking image

Jeep Liberty Trailer Wiring Installation And Review Videos

     

Roadmaster Battery Charge Line Kit Installation - 2012 Jeep Liberty- Video

Roadmaster Battery Charge Line Kit Installation - 2012 Jeep Liberty

Speaker 1: Today on this 2012 Jeep Liberty, we'll be having a look at and showing you how to install the Roadmaster battery charge line kit for towed vehicles, part number RM-156-25. Here's what our battery charge line kit looks line installed. Now what this will allow us to do is maintain the battery charge in our Liberty, so when we arrive at our destination and we unhook from our motor home. We don't have to worry about the battery being dead and our vehicle will be able to start first time without having to worry about jumping it, calling roadside assistance, or anything like that. We'll be able to start it, go on our explorations of the town, the mountains, wherever we're at, it doesn't matter. We'll have the freedom and the peace of mind to just get in our vehicle and go and be on about our way.Now this is ideal for vehicles that are being flat towed behind our motor home, that have a portable braking system that plug into the 12 volt outlet in your vehicle because those are drawing power off your vehicle's battery. more


Watch Video

9/11/2017 12:42:21 PM



Pollak 4-Pole Round Pin Socket Installation - 2007 Jeep Liberty- Video

Pollak 4-Pole Round Pin Socket Installation - 2007 Jeep Liberty

Today on our 2007 Jeep Liberty we'll be installing the Pollak 4-Way connector. Part number PK11410. As you'll see on this particular vehicle there was already a 4-way flat installed on the front. We're going to need to remove that 4-flat, just leaving the four wires, the yellow, the green, the brown, and the white. This particular vehicle also already has the Blue Ox Face Plate, part number BX1122 installed on it so we'll be connecting the four pin connector to the base plate using the base plate's hardware, the spacer block, as well as the screws, the lock washers, the nuts, as well as the self-tapping screws that hold it to the base plate. To wire this you'll need to go ahead and remove the center screw off the top of the 4-round. You'll then pull the center section out. more


Watch Video

9/4/2014 3:33:29 PM



  1